Model saw Schick G2 concept

Product No.:: 1500/5
Shipping time:: Available at short notice (abroad may vary)

3.225,00 EUR

plus 19% tax excl. Shipping costs

Description

Model saw Schick G2 concept -NEW-

Exact and time saving

Until now, on many models, saw cuts had to be made manually by virtue of the small space between the preparation or the diverging alignment of the teeth.…

In addition to the increased risk of injury, this mode of operation also entails an increased risk of damage to the plaster model and is also very time-consuming.

Save time and money

G2 Concept model saw
90 seconds *

Sawing by hand
180 seconds *

* Determined in the practice test on a model with 11 segments or 10 saw cuts.

Working method

The model to be sawn is placed on the saw table and fixed with two hands.The integrated line laser allows precise positioning of the cut.
When lowering the saw table, the saw blade plunges into the model from below and sets a clean cut parallel to the pins.
The exact depth of cut can now be determined optically perfectly, since when the teeth are diverging, the saw is sawn to the preparation limit and broken by hand at the intended break site.
Since the saw cuts are parallel to each other, all model segments can be easily removed from the model.

Technical data

Speed	7.500 rpm
Diamond saw blade	ø 85 x 20 mm segmented
Width of cut	0.3 mm
Cutting depth max.	26.5 mm
Laser category	3R
Suction support	Ø 38 mm
Operating voltage	230 V / 115 V / 100 V
Operating frequency	50 / 60 Hz
Input capacity	130 Watt
Width x Height x Depth	375 mm x 160 mm x 390 mm
Weight	4.5 kg

Scope of delivery

Schick G2 Concept model saw with integrated linke marking laser
Main cable
Diamond saw blade
Manual